How do you build a dry well in an outdoor shower?

How To Build A Dry Well In An Outdoor Shower

Building a dry well in an outdoor shower is not easy task. However, it can be done if you have the right skills and materials.

Building a dry well in an outdoor shower requires some basic tools like a drill, screwdriver, hammer and nails. You will need to bring your own bucket or plastic tub to collect rainwater from outside the house or building site.

If you are going to use a pump then you will need to get one too. If you don’t have any other source of water, then you may consider using a garden hose instead.

There are many different types of hoses available but they all work differently so it’s best to consult a professional before starting construction.

The first step is to plan out where the drain hole should go and what kind of pipe material would be needed for the job. Then you’ll need to figure out which type of pipe will be easiest to cut and fit into the drain hole.

When planning out the location of the drain hole, it’s helpful to keep in mind that there might be a wall behind your home that could block access to the area where you want to install a drain. Then you will need to select the appropriate size of pipe.

Planning Out Where The Drain Hole Will Go

A drain hole needs to be dug near the edge of your yard or building site. You want to dig a hole big enough for the pipe that will carry rainwater away from your home.

If you can’t find an area that’s easy to drill through then you may need to move the drain hole to a new location.

The next step is to drill a hole in the ground where you want the water to drain. Use a hammer and screwdriver (or other sharp object) to break up the ground first if it’s too hard to drill into.

Now comes the tricky part of cutting out the pipe pieces that will fit into the drain hole. This can be a challenge if you are planning on installing a large drain pipe.

If there is a wall behind your house, then you might not be able to dig a hole close enough to the edge to fit a large diameter pipe. You will also need to keep the pipe below ground so that it’s out of sight.

how do you build a dry well in an outdoor shower - remodelingmate.com

In some cases, it’s possible to lay the pipe through your yard and under the surface so that no one can see it from the road. It’s best to use a metal cutter to make nice clean cuts along the edges.

Otherwise, you’ll end up having to file the edges of the pipe pieces after they’re in place and that will waste time.

Installing The Pipe Pieces

Once you have all your pipe pieces cut to size, you can start installing them into the ground. Start by assembling the pipes onto each other so that they stay in place.

This is a much better solution because if you have to dig up your yard later to replace or fix part of the pipe, then it won’t be noticeable.

Connecting The Pipe To The Hose Bib

Once you’ve found the perfect spot to drill the drain hole, you will need to get a hose bib or spigot. You can purchase one at a home improvement store and have it installed by a professional if you don’t feel comfortable doing it yourself.

Use a wrench to tighten the joints so that they stay together.

Make sure the pipes are straight and will go down into the hole correctly before trying to put them into place. If you aren’t sure that they are straight then put something heavy on top while you make adjustments.

You don’t want the pipes to be crooked once they’re in the ground because you’ll have to dig them back out and try again. If you are comfortable doing it yourself then you can purchase a “hose bib in box” and start digging. Be sure to call your local government office and receive the proper permits first though.

how do you build a dry well in an outdoor shower - Image

The next step is to dig a small hole where the spigot will be installed. Depending on what kind of ground you have, you may need to bring in a jackhammer or hire a professional to do this step for you.

The last step is to fit the drain pipe into the drain hole. Check to make sure that water can flow freely out of your home into the drain pipe.

You also need to check for any other potential blockages after a heavy rain before you close up the hole in the yard.

Outdoor Drains For Other Buildings

Installing an outdoor drain for your house alone isn’t the only option. Once the hole is dug, you can get to work installing it.

If your spigot does not have an outside faucet then the water will drain out through it once it’s in place. You’ll most likely want to let it sit overnight so that all the air bubbles can escape from inside the pipe.

Finding The Best Location For Your Rain Barrel

A great spot to put your rain barrel is under an eave of your house. You can also choose to have them installed around the buildings on your property such as a garage or workshop.

This will help prevent water from running around the sides of the building and into the foundation instead.

Installing an outdoor drainpipe can be a big job so it’s probably best to leave this job to a professional if you’re not familiar with construction work. This is a great spot to keep it because water will naturally run off the house and into the barrel.

Just make sure that it’s not under a spout or a place where water tends to pool.

how do you build a dry well in an outdoor shower | remodelingmate.com

You can also place your rain barrel in your yard as long as it has a good drainage system. Use a section of wire mesh or landscape fabric at the bottom to keep leaves and other debris from getting inside the barrel.

Even if you are familiar with construction work, it’s not a bad idea to get someone who knows what they’re doing to help you out. If this is something that you want to take on yourself then you can find most of the supplies at a local home supply store.

Outdoor Drains for your yard is a good way to prevent major damage from water buildup around your home’s foundation. It can also help prevent flooding in your yard.

It’s best to use a professional if you are unfamiliar with construction. If you have any questions about how to get started, just give us a call and we’ll be glad to help.

Tips For Installing Outside Drains

Whether you’re installing a rain barrel or a system for your entire property, there are some things that you should keep in mind. If water can flow freely with the least amount of resistance possible then your water bill will be lower and you won’t have to worry about clogs inside your building.

The first thing to keep in mind is the size of your rain gutter. The maximum size for most downspouts is 3″.

This can vary a bit depending on the kind of roofing material you have so it’s best to measure before you buy anything.

Decide on a location for your barrel or barrels before you do any digging.

Keep The Drains Clean

how do you build a dry well in an outdoor shower - Picture

No matter what kind of rain gutter you have installed on your house, it’s important to keep the drains underneath them clean. Check them at least twice a year to make sure they are not clogged with leaves or other debris.

If this is something that isn’t done on a regular basis, it can lead to bigger issues in the future. It’s a good idea to keep them as high as possible so that water will drain quickly into them. If they’re too low then you might end up with a pool of water around them after a hard rain.You also need to make sure that there is a good slope away from your house.

The next step is to have the location graded so that water will flow freely into it. You can do this by hand or hire a company to do it for you.

If the location of your drain is lower than the rest of your yard, water may pool around it after a rain. Using a layer of large stones around the bottom will help keep the drain from becoming clogged up as well as directing the water into it.

Installing an Above Ground Rain Barrel

Installing a rain barrel is not that hard but you should still follow some basic safety precautions.

A Company Like Us Can Help

If you’re going to be installing a system for multiple buildings on your property or if you’re just not sure about any of this, then it might be a good idea to hire a professional. Anderson Exterior Plumbing is fully licensed and insured so you know that the job will get done right.

We have experience with all kinds of drainage systems for basements, crawl spaces, and outdoor locations. Call today to get your free estimate.

More Information

Sources & references used in this article: