Should you pressure wash wood siding?

The following are some tips on how to pressure wash your wood siding:

1) Pressure washing is not recommended if you have cracks or holes in the siding. If you do not want to replace all the damaged sections of your house, then it would be better to use other methods like sanding or caulking.

2) You can only pressure wash one section at a time. So make sure that you don’t overdo it!

3) Use a bucket with a tight fitting lid. Don’t forget to fill it up with water!

4) Do not use any kind of abrasive material such as sandpaper or a belt sander. These will cause damage to the wood surface. Instead, use a brush and some soapy water. Water can be found in most kitchen cupboards or bathrooms. Just pour some into the bucket and then wipe off any excess water using paper towels.

5) To avoid splinters, use a soft cloth instead of a hard plastic brush.

6) For best results, do not use too much water. Too much water can ruin the surface of the wood. You need to keep pressure on the area until it becomes dry. After pressure washing, let it air dry for 24 hours before applying stain or paint.

5) After pressure washing, let the wood dry completely. Then paint it again.

6) Never use bleach or ammonia to clean your wood siding. They can cause permanent damage to the wood surface. Also, they may stain your new paint job too!

7) Do not forget to wear the proper safety gear such as protective googles, gloves, and other types of clothing.

should you pressure wash wood siding - Picture

8) If you feel that using a power washer is too much work, then you can just use a garden hose and a soft brush. For hard to reach areas, it would be better to use a long pole with a brush attached to one end.

9) There are different types of wood siding.

7) Be careful not to step on the edge of your roof. One slip can spell disaster!

That’s all, folks! Hope you found this helpful. Good luck!

Sources & references used in this article: